| Displaying 1 to 10 (of 12 reviews) |
Result Pages: 1 |
|
 |
|
 |
Had a problem with it, Jason help got me going, gave me support, no problems
Rating: [5 of 5 Stars!] |
 |
|
|
 |
|
 |
I have a Workforce 600 and installed my CISS two and a half months ago. So far so good. In order to remove the lid/cover for the cartridges, I took a carpet knife to one end of the gray peg that attac...
Rating: [5 of 5 Stars!] |
 |
|
|
 |
|
 |
My Epson Workforce 610 has a door that covers the ink cartridge compartment. I had to melt down a section of the compartment sidewall in order to close the cover and not pinch the ink tubes. This was ...
Rating: [3 of 5 Stars!] |
 |
|
|
 |
|
 |
I was using low cost replacement cartridges from various online vendors for about 18 months for my Workforce 610. They worked fine for awhile, but I noticed a slow degradation in the quality over time...
Rating: [5 of 5 Stars!] |
 |
|
|
 |
|
 |
Like others have mentioned, the cover on the ink carriage is a problem. I had to break mine off. My kit failed to include everything shown in the online installation video, only one syringe and needle...
Rating: [4 of 5 Stars!] |
 |
|
|
 |
|
 |
I recently received the Continuous Ink System for Epson Workforce 610 and the ink cartidge did not fit properly into my printer and it kept popping out. I contacted CISinks and we tried to trouble sho...
Rating: [4 of 5 Stars!] |
 |
|
|
 |
|
 |
Ridiculously easy to install. Had to push the cartridges in and out several times to get the recognised but since then - perfect.
Rating: [5 of 5 Stars!] |
 |
|
|
 |
|
 |
Installed the CIS System on my Workforce 610 and it works great. It was harder than explained to remove the cover on the ink carriage but otherwise it was super easy.
Rating: [5 of 5 Stars!] |
 |
|
|
 |
|
 |
I have an Workforce 610, and i got a CISS, but i couldn't install it...
First problem, my printer has a cap on the cartridges, so i couldn't close the cap because of the wiring... so i broke my cap....
Rating: [3 of 5 Stars!] |
 |
|
|
 |
|
 |
Just a little note. When I installed it the printer came back with the message - Cartridge Not recognised ...... I switched off, pulled the cartridges up and pressed them down and restarted - same mes...
Rating: [5 of 5 Stars!] |
 |
|
|
 |
| Displaying 1 to 10 (of 12 reviews) |
Result Pages: 1 |
|
 |
|